![]() ![]() You typically do not need drives in these at all, but more memory certainly helps.Ģa - This is actually done very easily with ISC DHCP. Typically, you can set these up so they just listen on the interface and just accept any jobs passed to them. If you're doing the beowulf stuff, make sure that is configured properly. ![]() Like:ġa - If you want to run a distcc cluster, install distcc first, and setup the stuff so the 'client' nodes are pre-configured at boot up. This is probably going to be the hardest part, to be honest.ģ) Once you get the machines booting off the 'master', you're pretty much done. The good thing with these is they are very well supported by FBSD, and they're very configurable in how they do the network booting. ![]() I used all intel cards, as I had tons of leftover Intel 10/100. It has HDDs, lots of memory, the fastest network card (For instance, the Gig-E card if they're rare for you), and hooked up to the fastest port in your switch (For instance, Cisco switches often have 24 10/100 and 2 "uplink" Gig-E ports).Ģ) Setup network booting. I did about 10-15 computers in my garage (I fix/repair computers, and these were old P4 throwaways).ġ) Using one of the computers, you install it like a normal server. One thing I did was very similar to the second link. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |